Rare or not, need to make room in storage.
All fiberglass, all seem to be original, red
paint, all seem to be consistent with either
a rare '67 GT/CS prototype OR a special
Spring 1967 New Jersey Mustang dealer promo.
Priced below reproductions, the decklid in
particluar appears to be solid heavy-duty
Ford fiberglass with the correct "curve."
(1) Decklid (with Ford part #C7ZB-65-915C2)
red paint over stripes and red paint over off-white
(2) GT/CS Light Housing (no part number)
red, rough-cut gas cap hole, many screw-holes
(3) Pair of Side Scoops
red, white GT/CS logo and stripe, appears to be
'67 Shelby type vent duct, no mesh screens
Sell 1, 2, and 3 as a lot for $550. cash.
Must arrange for pickup in Southern California
(San Fernando Valley). Sorry, no end caps
and no photos (digital camera died).
First serious response with cash, gets these,
if not they will go to Ebay.
Remove "(nospamm)" from e-mail address below
brewsale@(nospamm)hotmail.com
All fiberglass, all seem to be original, red
paint, all seem to be consistent with either
a rare '67 GT/CS prototype OR a special
Spring 1967 New Jersey Mustang dealer promo.
Priced below reproductions, the decklid in
particluar appears to be solid heavy-duty
Ford fiberglass with the correct "curve."
(1) Decklid (with Ford part #C7ZB-65-915C2)
red paint over stripes and red paint over off-white
(2) GT/CS Light Housing (no part number)
red, rough-cut gas cap hole, many screw-holes
(3) Pair of Side Scoops
red, white GT/CS logo and stripe, appears to be
'67 Shelby type vent duct, no mesh screens
Sell 1, 2, and 3 as a lot for $550. cash.
Must arrange for pickup in Southern California
(San Fernando Valley). Sorry, no end caps
and no photos (digital camera died).
First serious response with cash, gets these,
if not they will go to Ebay.
Remove "(nospamm)" from e-mail address below
brewsale@(nospamm)hotmail.com