• Welcome to the CaliforniaSpecial.com forums! - You are currently viewing the forums as a GUEST. To take advantage of all our site features, please take a moment to join our community! It's fast, simple and absolutely free.

    If you have problems registering or can't log into your account, please contact Admin.

    Please Note: If you are an existing member and your password no longer works, click here to reset it.

1968 Fog light wiring / Hi beam switch measurement

pnsy56shop

Well-known member
Joined
May 1, 2009
Messages
52
Location
Berlin, NJ
Hello
Marchal fog light power feed
1. I'm working of the fog light power feed, in the assembly manual it shows from the gray fog light switch wire a lead wire that runs under the dash through the firewall across the support brace to a junction block on the apron (below the solenoid a little to closer to the shock tower) and another wire going from the junction block to the solenoid.
Is this correct for the GT/CS Marchal fog lights? Would someone share a picture of their engine compartment of the wire and junction block if this is the way it was run or if not share how the fog lights are powered.

2. The assembly manual also shows a plastic wire clip on the back side of the fog light switch and the manual shows a wire clip on each Marchal mounting brackets were these clips used on GT/CS at the San Jose plant?

3, What is measurement for the hi beam switch, from kick panel side and from the seat platform up to the switch.
Thanks
PNSY56SHOP
 
Top