franklinair
Well-known member
- Joined
- Mar 1, 2007
- Messages
- 4,744
A job I've not done before: The front vent window seal & rear quarter window vertical seal. Anyone done these? Process? Tips?
Neil
Neil
COMMUNITY
1968 GT/CS & HCS
2007+ GT/CS
1966-1967 HCS
-
Welcome to the CaliforniaSpecial.com forums! - You are currently viewing the forums as a GUEST. To take advantage of all our site features, please take a moment to join our community! It's fast, simple and absolutely free.If you have problems registering or can't log into your account, please contact Admin.Please Note: If you are an existing member and your password no longer works, click here to reset it.
1968 Window seals
- Thread starter franklinair
- Start date
OP
OP
franklinair
Well-known member
- Joined
- Mar 1, 2007
- Messages
- 4,744
FYI: (I didn't know this before)
To replace the rear 1/4 window vertical seal: there is a Phillips head screw at the bottom of the seal. Remove it, and the seal slides downward in its track. (I used vise grip pliers to grip the old rubber and just tapped it downward with a mallet, and it slid out very easily.)
I lubed the new seal, and it slid upwards very easily by hand.
Neil
To replace the rear 1/4 window vertical seal: there is a Phillips head screw at the bottom of the seal. Remove it, and the seal slides downward in its track. (I used vise grip pliers to grip the old rubber and just tapped it downward with a mallet, and it slid out very easily.)
I lubed the new seal, and it slid upwards very easily by hand.
Neil
nikzack
Well-known member
Thank you
Great info Neil :smile:
Great info Neil :smile:
