Search results

Hood light clips Hey Neil, I found the exact clip at the local hardware store. You may want to give them a try. Hope this helps. Joel

Hello, I am trying to locate JBART a member here about some parts he may have for sale. Does anyone have an address, or phone number? I have been trying his e-mail address on the site but I get no responce. I have not saw him on the site in reasent months. Thanks, Joel

Looking for JBART

Hello, I am trying to locate a member of our site-- JBART --I am looking for some parts he may have. I have tried e-miling him with no responce. Does anyone have an address, or phone number. Thanks, Joel

Hi, My name is Joel, I purchased a fog light bulb holder from you a while back. Do you have any bulbs you would like to sell? My e-mail address is jomargfran@aol.com. Thanks

Rich, Could you please scan that banner for me the copy I have does not have it. Thanks, Joel

Looking for a place to purchase a Marchal fog light bulb for my 68 CS/GT. The number on the bulb is 1282 Phillips 12 V 45W Anyone know where I can purchase one. Thanks

Carlisle ad Hey, Yes, that's my car. Tom with his red High Country special, and I were asked to show our cars for the ALL FORD WEEKEND. Thanks for telling me abut the add, I would have missed it. Joel

scoop Hey Rob, For the black part behind the screen on the side scoops,I used some black rubber roofing material. It worked great. Joel

Yes, I emailed you a while back about the lamp holder.My name is Joel, what are you asking for it? My e-mail address is jomargfran@aol.com Thanks

Hi, I am still interested in the socket part for the fog light. Thanks, Joel

Fog lights Hi, Did you ever get my response to the pictures you sent me of the sockets for the fog lights. Thanks, Joel

fog lights Yes I am interested in some inside parts if you have any. I will send you a private message with my e-mail address. Thanks, Joel

removing under coating I used a small pan with some regular gas in it, line the floor with card board because it is a mess. I would rub an area and let it soak for a bit, then I would do the same thing again, in about ten minutes. You can do big sections at a time because you are always going...

Dry ice I have used dry ice at work for cleaning machinery. I found it to be very expensive, and slow, plus you have to order the ice, and use it as soon as posible because it will disipate, and it is expensive to purchase. We no longer use unless we have too. Joel

Hey Shaun, Try Mechnicsburg PA. it's about 4-5 miles North of Carlisle. I know they have a nice Hampton Inn there, I stayed there a few times. I am almost sure they have some other hotels there also. Joel

I want to install the decals on inside of my trunk lid, and I want to make sure I put them in the right place. There are three sections on the inside of the trunk lid, one big area in the middle where I think the jack instruction decal goes. then there are two smaller sections one on each side...

For me it was replacing the wing window frames in the front doors, I don't think I will ever do that again.

3" C/S Decal Hi, I pretty sure Paul was going to have some new original decals made to go with his new book, he may have them already. Maybe you could e-mail him. Joel

removing steering wheel Another way to remove your steering wheel is to take off your pad with the two phillip screws, remove the center bolt, and sometimes you can borrow a steering wheel puller at your local parts store,or rent one. (cheep to rent)You should first check for marks on the bolt...