Search results

Robert i believe, that these are the pedestal mount, street versions so that the revised oil passages should not be necessary. Thank you for the pics and the added info as well.

what about the underdash parts, not sure what should or should not be there. thanks for the reply clubpro and bluestang

The TP heads are similar to the 427 variety the port runs right through the pushrod, so there is a tube for it in the middle of the port, and the ports are literally round on the intake side. They are massive... lol and have a matched single plane dual quad intake. Its my understanding their...

Paul other than the fact they almost made production... from what little i can find it was a halfhearted effort at best, since the scca didnt pursue the homoligation issue. I have searched the net high and low and have turned up very little on this parts as a whole.

thanks for the rapid replies i am a little bummed out that there isnt any more info to be had on these cars through the dealer. Yes my car was a heater delete car, did your car clubpro, or bluestang also have the dealer installed air? My car by the vin i stated earlier is a C code sadly but as...

i have a marti report but it is a basic report the dealer listed is 721200, also the vin on the car is 8r01c143535, as i said i have bills of sale back to the original owner, and the manual with the faded ink would tend to agree it was sold in honalulu.

The gt/cs i recently purchased has a bill of sale from the original owner stating it was bought at honalulu ford, even the original owners manual has it handwritten in in what has to be 40 year old ink. I guess the question is how would i go about confirming this, or seeing if the car was sold...

Thanks for all the intrest robert, lol she is a long way from shows, and needs much history clarification before she gets to a show. lol suprised to see there are not any purists screaming to keep her stock...

Actually i am getting them through a local builder with a fully equipped shop, dyno and flow bench included. Thanks for the suggestion of a builder though, actually this motor will be 1 of 2 347 tunnel port motors being built. the other will be going to a 67 fastback. I intend to go with a T5...

yes the TP heads and intake should very soon be in my possesion. I was just curious since not original if it would detract or since they are quite rare add to the value.

would building my original 68 289 (actually a 302 block?) matching numbers motor as a 347 tunnel port motor actually signifigantly take away from its value or add to it??

both aprons are a reproduction peice actually basically the whole front clip was replaced along with the floorpans, and the rear frame rails. So i shouldnt take the fact that the stamping is no longer there as a liability i do have the vin in the correct place on the windshield as well as the...

I recently purchased a basket case gt/cs...... a previous thread i had mentioned missing parts for the radiator support well upon going through all the parts further the area where the vin stamping would be has been replaced, and the holes to bolt the fender to are missing due to the...

Thanks you guys are the best, had a bit of a scare as to what i was missing for a while those would appear to be what im missing the highlighted portion of the pdf. Cant thank you all enough for the help.

those are what i have, the issue is the welded in piece on the radiator support is missing. Thanks for the quick response.

Hi all new to the Forum Just purchased a candyapple red gt/cs, unfortunatly for me the previous owner started a Resto, and the brackets that attach to the radiator support were not saved when it was replaced, so i have the bracket with the wire clip, but not what it attaches to on the car, i...