Search results

I've never installed one. How to you secure the blind rivets? Neil

Did any CS's have the dash/windshield pillar pads installed? Neil

The padded interior 1/4 panel is padded, and slightly different contour at the upper corner compared to a Standard panel. Anyone have a photo of one installed? Any trick I should know about? Neil

HAPPY BIRTHDAY Mike (somethingspecial & Registrar) Jewell. Did you try to slip this by? All the best my friend. Neil

The grill is complete, Fog Lights installed (after re-wiring). Neil

I've decided not to use the upper console in my current CS project. New switches, new light assemblies, new woodgrain applique'. It's currently Nugget Gold, but I can dye it any color. PM me if interested. Neil

I need to have the Deluxe steering wheel and Nugget Gold seatbelts refurbished. Recommendations needed. Neil

Where do I purchase Lucas bulbs LLB453 (or H-1?) I need a pair. As an aside: I noticed that with the fog lights switch ON (no headlights ON) just the Fog Light switch ON, with Ign SW Acc or ON, the front side marker lights are also ON. Never noticed this before. Normal? Neil

Where can I find the wiring diagram for the Lucas fog lights. It's basically only a 2 wire circuit, but not in my Mustang Wiring Diagram book. Neil

I purchased a set of sill plates for the Highland Green C/S. NOT HAPPY. Taiwan piece of junk. Not only are they flimsy, the screw holes are displaced 1/4". Can anyone suggest a decent replacement? Quality & fitment are my priorities. Neil:mad:

Assembling the instrument cluster: Adjacent to the right turn(Green) arrow there are two additional lights with no jewel lenses installed. I need to know what color/lettering (if any) is required for these two indications, and what they're for. The wires for the light next to the T/S light are...

I found a GOOD source for stripe kits: Graphic Express, 352-341-0077 in Florida. I botched the decklid stripe on my CS, and had resigned myself to the fact I'd have to order a complete kit. Not so. These folks were helpful, and I was able to purchase just the decklid section I need. Good...

Peggy and I are off to Calloway Gardens in Georgia for my annual get together with my brothers & sister, and spouses this weekend. Neil

My memory bank crashed:rolleyes: Getting ready to install the striping. The stripes have paper on both sides, one side paper is a thicker paper than the other. Which peels off to apply the stripe to the body? The instructions mention cleaning the surface with Naptha to be sure no polish...

Anyone have a photos of the door seals? Want to be sure of upper attach points, front & rear of doors. Neil

I'm going to be needing a pair of side scoops when I start on my black CS. The ones with the car are not correct (don't know their application). Neil

This is a new one on me: I've never seen a small block Mustang develop cracks in a shock tower. These are on the pax side, front & rear sides of the shock tower. Looks like a good penetrating weld will take care of them. Neil

Getting ready to install the 2 new side scoops. Installed the center stud. The 2 front sheetmetal screw location is perplexing: It appears that the angle for the 2 screws through the front of the scoop is perpendicular to the quarter panel metal. :confused: PMN's book, page 107 shows a drawing...

I have a pair of primo '68 seat backs, no headrests, and a primo pair of '69 headrests. I also have a pair of trashed '69 seatbacks with headrests. Can the hardware from the '69 seatbacks be switched to the '68 seatbacks? Neil

I once had a carpeted dashpad cover for the top of the dashpad. Now I want another, but can't find a listing for it. Anyone know who may still carry/sell these? Neil