1968 Door vapor barrier

[retroman99]

what type of adhesive do you use for the paper vapor barrier that goes on the doors prior to the interior panel. it looks like it needs to be stay tacky and soft and allow for removal incase you need to access the window or door handle mechanisms in the future.

 

[Ruppstang]

It was a material like 3M 8509 window glazing and bedding. I usually have enough left after the windshield to do the water shields. 3M black strip calk would work as well.

 

[dalorzo_f]

+1 on the strip caulk, a bit less messy than the caulking gun bedding and glazing goop...

I've used both of these and the 3M is a bit tackier, if a bit more difficult to apply due to that stickiness (it likes to stick to your hands more than the car!) :tongue:

https://www.npdlink.com/store/products/mustang_stripping_caulk_cord_gray_correct_19-106656-528.html

https://www.npdlink.com/store/produ...caulk_cord_black_correct_3_16-106653-528.html

 

[franklinair]

I have some left over of the AMK caulk. PM me how much you need + address, and I'll send it to you.

Neil

 

[retroman99]

I have some left over of the AMK caulk. PM me how much you need + address, and I'll send it to you.

Neil

Neil
thank you sent you a PM. thanks to all the other replies as well. funny as much as I have surfed the NPD on-line catalogue I didn't see this stuff.

 

[slimt]

on any car I use barrier paper on.. I used dumdum.. It can be had at any bodyshop supply... and is reusable if you need to re-adjust door glass or what ever.. pretty much the same as the original stuff used.