dalorzo_f
Well-known member
Installed it today. Decided to punch a few new holes and use the valence screws. They sit about halfway between where the ones in the part were and the edge. It is a NPD "lumpy" one, so closer to the macerated OEM than the flat sheet repros.
Not "correct" but it fits pretty good and I did not have to drill any new holes (I hate drilling/cutting anything FoMoCo put on the car!)
Figure in time it will flop down a bit and work OK.
Not "correct" but it fits pretty good and I did not have to drill any new holes (I hate drilling/cutting anything FoMoCo put on the car!)
Figure in time it will flop down a bit and work OK.
