1968 Radiator Fan Shroud

[Mosesatm]

Have any of you installed a fan shroud on a Champion aluminum radiator? Will a standard aftermarket shroud for a large-radiator car work?

Please ignore the goofy top bracket; it’s just temporary.

Thanks

Arlie

 

[CougarCJ]

Arlie, If you can get me measurements of the side holes. i.e. horizontal and vertical measurements, I can compare to stock Mustang shrouds. Hopefully the radiator is situated so that the fan is will be centered in the shroud with those mounting holes.

 

[Mosesatm]

HI Scott,
The holes are 25" x 10", but the vertical dimension can change by drilling new holes. The horizontal dimension is pretty well set, but I should be able to trim the shroud if needed.

 

[CougarCJ]

Good news, the 24 inch fan shrouds for Mustangs have 25 inches on center for the horizontal. Vertical is 10-1/4, might have to file a bit to fit fasteners. Measured from a Daniel Carpenter manufactured small block fans shroud C9OZ-8146.
Same for 1968-69 289/302/351W.