• Welcome to the CaliforniaSpecial.com forums! - You are currently viewing the forums as a GUEST. To take advantage of all our site features, please take a moment to join our community! It's fast, simple and absolutely free.

    If you have problems registering or can't log into your account, please contact Admin.

    Please Note: If you are an existing member and your password no longer works, click here to reset it.

1968 What color is the underside of your GT/CS?

classicsguy

Well-known member
Joined
Aug 21, 2002
Messages
1,535
Is the underside of your GT/CS/HCS painted body color or black or like it came from factory with red oxide and overspray ( Not sure if it came that way from Ford) Maybe somene can chip in on this. Or maybe its full of dirt and grime from driving it!!
 

dalorzo_f

Well-known member
Joined
Jan 7, 2006
Messages
1,886
Location
Brisbane Australia
San Jose in '68 was generally red oxide. Dealer prep in rust areas was often full black undercoat. So both can be "correct" depending on if you mean factory or as delivered to the customer...
 

Doug

Well-known member
Joined
Apr 23, 2007
Messages
558
Location
Valencia, California
This might be correct -
 

Attachments

  • 11.JPG
    11.JPG
    103.1 KB · Views: 64

J_Speegle

Well-known member
Joined
Jun 19, 2006
Messages
488
Underside of these cars is either one or two tones of epoxy (so it has a smooth slightly glossy look) red oxide primer sealer. The color can vary from a muddy brownish to a pale pinkish red oxide color depending on what week or month your car was built.

Over this (in areas close to the rocker panel and rear wheelwells) we have body color overspray (sometimes to the driveline tunnel) Over this we typically have the semi-gloss black overspray from the pinch weld black out process. Not as far in on the floors since the gun used a lower operating pressure

Hope this helps
 

GT/CS S Code

Well-known member
Joined
Dec 26, 2007
Messages
912
Location
Victoria, B.C., Canada
Underneath ...

Is the underside of your GT/CS/HCS painted body color or black or like it came from factory with red oxide and overspray ( Not sure if it came that way from Ford) Maybe somene can chip in on this. Or maybe its full of dirt and grime from driving it!!

Ours is "brown road dirt", speckled with "black asphalt" and a few small patches of light "red rust" ...
:grin:
... mind you our car gets a fair bit of road use during the Spring and Summer while it is licenced and driveable ...

(All kidding aside, we're not sure on the original finish colours as the car was cleaned up and re-painted before we bought it.)
 

Mosesatm

Well-known member
Joined
Jan 18, 2005
Messages
9,178
Were all pinch welds painted black or only those on light-colored cars?
 

Ruppstang

Well-known member
Joined
May 22, 2009
Messages
3,080
We have even seen the black out spray on black cars. I think that the guy on the line hit every car that went by. Marty
 

J_Speegle

Well-known member
Joined
Jun 19, 2006
Messages
488
Were all pinch welds painted black or only those on light-colored cars?

Seen up to dark blue and green cars done but have not seen evidence (though I believe at least some might have been done) of a black car being dome. Of course over spray from the body color would really blend between the two

Would not believe everything we see in the FAM ;) too many examples of where those practices don't match up on real cars
 

Ruppstang

Well-known member
Joined
May 22, 2009
Messages
3,080
Seems like I remember 67-68 gold card Danny Truit saying that his black 68 fastback was blacked out. You could tell the differance in the gloss of the black. Marty
 
Top