• Welcome to the CaliforniaSpecial.com forums! - You are currently viewing the forums as a GUEST. To take advantage of all our site features, please take a moment to join our community! It's fast, simple and absolutely free.

    If you have problems registering or can't log into your account, please contact Admin.

    Please Note: If you are an existing member and your password no longer works, click here to reset it.

Installing Stripes With Guide Tape

PFSlim

Well-known member
Joined
Feb 9, 2004
Messages
1,546
Location
Weatherby Lake, MO
We used the measurements from Paul N's book to place the stripes down the car. Then, we used a chalk line to "snap" a straight line down lenght of car. Next, we ran a piece of tape down the chalk line and then wiped off any access chalk. The tape then became our guide to run stripes.

Helpful Hint: You do not dip the stripe in a water bucket or soapy water. Soapy water is applied to the surface of the car, remove the backing from the stripe and place stripe on the car.

Helpful Hint: Use a good bondo spreader to assist in getting bubbles out from under stripe. If stripes are applied carefully, not many bubbles will show up.

Helpful Hint: Remove outer stripe backing after the stripe has been applied and wait for a few seconds. Not to long, but not to fast either. The small top and bottom stripes will want to come off car if to much soapy water is applied. Watch for small top and bottom stripes wanting to waver (up and down). This will tell you if you are pulling the backing off to soon.

Helpful Hint: I think it is very important to place stripes on a car in an area where you can get back away from the car and ensure the stripe is straight and pleasing to the eye.

Paul
 

Attachments

  • Stang473.JPG
    Stang473.JPG
    59.1 KB · Views: 239
  • Stang471.JPG
    Stang471.JPG
    59.7 KB · Views: 249
Top