dalorzo_f
Well-known member
Know the lid sits high in comparison to the end caps. But I found I needed to shim the striker on the lid down about 1/8" to get it to latch. The latch is full up, exactly where it was before. Based on the old toothed washer dents in the support bracket.
Is this a common requirement? I used the "incorrect" and super soft 69 style (trapezoid, not "C" type) trunk seal and theres still no way it will latch without the shims.
Is this a common requirement? I used the "incorrect" and super soft 69 style (trapezoid, not "C" type) trunk seal and theres still no way it will latch without the shims.